Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500TN Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
MAINTENANCE DCS-2500TN
52 X7508220500
© 7/23 ECHO Incorporated
Saw Chain Maintenance
Remove the battery before sharpening chain. Always wear
gloves when working on chain. Otherwise serious personal
injury may result.
The following factors will increase the risk of kickback:
◆ Top plate angle too large
◆ File diameter too small
◆ Depth gauge too large
Note: These angles are referred to as 80TXL. For chains of other
brands, follow manufacturers instructions.
Properly filed cutters are shown below.
A. Top plate angle 80TXL 25°
B. Top plate cutting angle 80TXL; 70°
C. Depth gauge 80TXL; 0.025 in
D. Parallel