Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500TN Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
OPERATION DCS-2500TN
38 X7508220500
© 7/23 ECHO Incorporated
• If the LED remains lit, operation is normal.
• If the LED flashes once per second, the battery needs to be charged.
• The LED flashes four times per second when the chain brake is
ACTIVATED. To disengage the chain brake, pull front hand guard towards
the operator to the chain brake RELEASED position. The saw will power
itself off in about 5 minutes if the chain brake remains in the ACTIVATED
position
• The LED flashes four times per second when the chain brake is
ACTIVATED. To disengage the chain brake, pull front hand guard towards
the operator to the chain brake RELEASED position. The saw will power
itself off in about 5 minutes if the chain brake remains in the ACTIVATED
position.
Stopping the Unit
1. Release trigger switch and trigger switch lockout, and allow saw chain
to stop.
2. Push power button to turn off power to unit.
Note: Power indicator LED (C) turns off when power to unit is turned
off.
◆ When the trigger switch is released, the saw chain
automatically stops. Motor control changes depending on
temperature of the battery therefore stop time of the saw
chain might not be consistent.
◆ If the power button does not stop the chain saw, remove
the battery to stop the power supply to chain saw. Have
your authorized servicing dealer repair power button
before using chain saw again.
◆ If the saw chain does not stop when the trigger switch and
trigger switch lockout are released, activate chain brake
then remove battery to stop the power supply to chain
saw. Have your authorized servicing dealer repair unit
before using again.