Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500TN Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
ASSEMBLY DCS-2500TN
36 X7508220500
© 7/23 ECHO Incorporated
Removing the Battery
To remove battery, press
battery latch, and slide
battery out.
When the battery is difficult to remove:
1. Place saw on a hard flat
surface.
2. Press battery latch and
push bottom of battery
against the hard surface.
3. Slide battery out of saw.
Hanging and Lifting
Hooks
Hanging Hook (A):
Attach a rope or carabiner to
prevent accidental dropping
of saw while working in a
tree.
Lifting Hook (B):
Use to hook and unhook from
harness in one quick
movement.
A
C
B