Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500TN Chainsaw
- Table of Contents
 - Introduction
 - Safety
- For safe use of your product
 - International Symbols
 - Location in which the safety decal is attached
 - Handling the Product
 - Chainsaw Safety Warnings
 - Causes and Operator Prevention of Kickback
 - Kickback Safety Precautions
 - General Precautions
 - Precautions for Use
- Users of the product
 - Environment of Use and Operation
 - Vibration and Cold
 - Repetitive stress injuries
 - Transport of the product
 - Starting the unit
 - Once the unit has started, check for abnormal vibrations and sounds.
 - Disconnect the battery:
 - Do not touch high temperature or high voltage components while the product is running.
 - Turn off the unit when checking or maintaining the product.
 - Turn off the unit immediately if anything goes wrong.
 - A ten meter radius is a danger zone.
 - Using the product.
 - Make sure that the saw chain is stopped before putting the unit on the ground
 
 - Protective Gear
 
 - Description
 - Contents
 - Assembly
 - Operation
 - Maintenance
 - Troubleshooting
 - Storage
 - Specifications
 - Product Registration
 - Warranty
 - Notes
 
 
ASSEMBLY DCS-2500TN
34 X7508220500
© 7/23 ECHO Incorporated
1. Plug charger AC cord in the 
wall outlet.
2. Align ridges on battery with 
grooves on charger, and slide 
battery into charger.
3. During normal charging, the 
charger LED (A) will blink 
GREEN.
If charger detects a problem, LED will blink RED. Remove battery 
from charger, clear obstructions from contacts and reinstall battery 
into charger. If battery is outside acceptable temperature range (See 
Recommended Ambient Temperature chart) LED will remain RED.
4. When charging is complete, 
LED will remain GREEN. See 
battery manual for charging 
time. 
5. Verify battery is fully charged. 
Remove battery from charger, 
press battery charge status 
button (B), and check LED 
display.
• One green light indicates that 
the battery has 1-24% charge.
• Two green lights indicate that 
the battery has 25-54% charge.
• Three green lights indicate that the battery has 55-79% charge.
• Four green lights indicate that the battery has 80-100% charge.
6. Unplug charger AC cord from the wall outlet.
A
B










