Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500TN Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
SAFETY DCS-2500TN
16 X7508220500
© 7/23 ECHO Incorporated
• Keep handles dry, clean, and free from oil and grease. Greasy, oily
handles are slippery causing loss of control.
• Cut wood only. Do not use chainsaw for purposes not intended. For
example: do not use chainsaw for cutting plastic, masonry or non-wood
building materials. Use of the chainsaw for operations different than
intended could result in a hazardous situation.
Using improper replacement components or removing safety
devices may result in serious or fatal injury.
Unit includes safety devices that reduce the likelihood of
kickback:
◆ Chain brake - brake actuated by kickback energy, not
manual activation.
◆ Reduced-kickback guide bar - reduced nose radius guide
bar.
◆ Low-kickback saw chain - saw chain that meets ANSI
kickback performance requirements when configured with
the bar/chain recommendations in this manual.
◆ Front hand guard - a structural barrier between the front
handle of a chain saw and the guide bar.
Causes and Operator Prevention of Kickback
Kickback may occur when the nose or tip of the guide bar touches an
object, or when the wood closes in and pinches the saw chain in the cut.
Tip contact in some cases may cause a sudden reverse reaction, kicking
the guide bar up and back towards the operator. Pinching the saw chain
along the top of the guide bar may push the guide bar rapidly back towards
the operator. Either of these reactions may cause you to lose control of the
saw which could result in serious personal injury. Do not rely exclusively
upon the safety devices built into your saw. As a chainsaw user, you
should take several steps to keep your cutting jobs free from accident or
injury. Kickback is the result of tool misuse and/or incorrect operating
procedures or conditions and can be avoided by taking proper precautions
as given below: