Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500T Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- One-handed use is intended for trained tree service professionals only.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
DCS-2500T STORAGE
X7508220201 59
© 4/22 ECHO Incorporated
Checking and maintenance requires specialist knowledge. If you are
unable to check and maintain the product or deal with a fault yourself,
consult your dealer. Do not attempt to dismantle the product. Consult your
dealer in the event of a problem that is not covered in the table above, or
other such concerns. For spare parts and consumables, please use only
genuine parts and designated products and components. Using parts from
other manufacturers or non-designated components may result in a
malfunction.
STORAGE
Storage
Do Not Store In An Enclosure Where Combustible Fumes May
Accumulate. Fire May Result.
When storing the product for long periods of time, ensure that the following
preparations for storage are carried out.
Chain Saw
Do not store your unit without performing protective storage maintenance
which includes the following:
1. Turn power to unit off.
2. Remove Battery.
3. Remove accumulation of dirt and debris from exterior of unit.
4. Tighten all screws and nuts.
5. Install guide bar cover.
6. Cover battery compartment of chain saw.
7. Store unit in a dry, dust-free place out of the reach of children.