Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500T Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- One-handed use is intended for trained tree service professionals only.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
TROUBLESHOOTING DCS-2500T
58 X7508220201
© 4/22 ECHO Incorporated
TROUBLESHOOTING
Trouble Cause Solution
Red Charger LED flashes or
does not light up
Plug not connected to
power outlet
Plug in the charger
Battery not installed
properly
Check the battery
installation
Obstructed connection Reinstall battery again
after remove obstructions
from connection
Fault in the charger Consult your dealer
Fault in the battery Consult your dealer
Unit will not turn on Battery not installed
properly
Check the battery
installation
Unit does not run when
turned on
Battery discharged Charge the battery
Battery outside
acceptable
temperature range
Remove the battery and
allow to cool
Running time is too short
Battery outside
acceptable
temperature range
Remove the battery and
allow to cool
Unit electronics too hot Turn unit off and allow to
cool
Battery discharged Charge the battery
Cutting attachment
dirty
Clean the cutting
attachment
Chain tension too hight Readjust chain tension
Chain oil does not come out No oil in the oil tank Fill the chain oil
Clogged chain oil pipe
or oil filter
Clean the chain oil pipe
and oil filter
Fault in the oil passage Consult your dealer
Unit vibrates excessively Fault in internal parts Consult your dealer