Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500T Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- One-handed use is intended for trained tree service professionals only.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
DCS-2500T MAINTENANCE
X7508220201 57
© 4/22 ECHO Incorporated
Air Filter
1. Remove battery.
2. Remove air filter (I).
3. Clean air filter area with
compressed air.
4. Brush debris from filter.
If filter is excessively
dirty or no longer fits
properly, replace it.
5. Dry filter completely.
6. Reinstall filter.
Replacement Guide Bar and Chain
Only use replacement bars and chains specified by the manufacture
or the equivalent. Otherwise, there may be a risk of accidents and
damage to the machine.
Bars and Chains
Guide Bar Saw Chain
Length mm (in) Echo Part No. Pitch mm (in) Type Links
305 (12) 12A0CD3745 9.53 (3/8) 91PXL45 45
I