Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500T Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- One-handed use is intended for trained tree service professionals only.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
MAINTENANCE DCS-2500T
56 X7508220201
© 4/22 ECHO Incorporated
Automatic Oiler
1. The discharge volume
of the automatic oiler is
adjusted to 7 mL/min
approximately at 7000 r/
min, prior to shipment
from factory.
2. To increase the delivery
volume, turn the
adjusting screw (F)
counterclockwise.
3. When adjusting screw touches stops, it has reached maximum
discharge volume. (13 mL/min at 7000 r/min).
4. Do not turn the adjusting screw beyond the maximum or minimum limit
of volume adjustment.
Cooling System
1. Check periodically.
2. Remove debris blocking
air inlet (G) and outlet
(H).
Clean the unit with the air filter attached to it in order to prevent trash
from entering inside.
F
C
G
H