Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500T Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- One-handed use is intended for trained tree service professionals only.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
DCS-2500T MAINTENANCE
X7508220201 55
© 4/22 ECHO Incorporated
Guide Bar
Do not degrease brake drums and brake bands. After cleaning, apply
a thin oil between the brake drum and the brake band.
1. Clean before using. Use
a small screwdriver or
wire to clean the guide
bar groove (B). Clean
oil holes (C) with a wire.
2. Reverse the bar
periodically.
3. Check sprocket (D) and
clean the bar mount
area before installation
of the guide bar.
Replace either if worn.
Sprocket
1. A damaged sprocket
can cause premature
damage or wear to saw
chain.
2. Check sprocket when
you install new chain.
Replace if worn 0.5 mm
or more.
3. Check brake drum (E).
If it will not rotate by
hand, see your
authorized dealer for
repair.
B
C
D
E