Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500T Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- One-handed use is intended for trained tree service professionals only.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
MAINTENANCE DCS-2500T
52 X7508220201
© 4/22 ECHO Incorporated
Note: These angles are referred to as 91PXL. For chains of other
brands, follow manufacturers instructions.
Properly filed cutters are shown below.
A. Top plate angle 91PXL 30°
B. Top plate cutting angle 91PXL; 55°
C. Depth gauge 91PXL; 0.65 mm
D. Parallel
Never operate a chainsaw with a
dull or damaged chain. If the chain
requires excessive pressure to cut
or produces dust instead of wood
chips then inspect the cutters for
damage. When sharpening the
chain the objective will be to
maintain the same angles and
profiles throughout its life as when
it was new. Inspect the chain for
damage or wear every time you
refuel your chainsaw.
Sharpening
In order to file the chain correctly
you need: round file and file
holder, flat file and a depth gauge
tool. By using the correct file size
(91PXL; 4.0 mm Round file) and
a file holder, it is easier to receive
a good result.