Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500T Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- One-handed use is intended for trained tree service professionals only.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
DCS-2500T MAINTENANCE
X7508220201 51
© 4/22 ECHO Incorporated
If not maintained properly, the product may pose a serious risk
to physical health.
If not maintained properly, the product's performance may
deteriorate. Time intervals shown are maximum. Actual use and your
experience will determine the frequency of required maintenance. If
you continuously use vegetable based chain oil, inspect and do
maintenance often. When you find anything wrong, ask your ECHO
dealer for repair.
Saw Chain Maintenance
Remove the battery before sharpening chain. Always wear
gloves when working on chain. Otherwise serious personal
injury may result.
The following factors will increase the risk of kickback:
◆ Top plate angle too large
◆ File diameter too small
◆ Depth gauge too large
Cooling System / Air
Filter
Inspect / Clean / Replace
2
Chain Brake Inspect / Clean / Replace 2
Screws / Nuts / Bolts Inspect / Tighten / Replace 1
Monthly
Oil Filter / Oil Tank Inspect / Clean / Replace 1
Sprocket Inspect / Replace 2
COMPONENT OR
SYSTEM
MAINTENANCE PROCEDURE Skill Level