Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500T Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- One-handed use is intended for trained tree service professionals only.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
DCS-2500T OPERATION
X7508220201 35
© 4/22 ECHO Incorporated
Removing the Battery
To remove battery, press
battery latch, and slide
battery out.
When the battery is difficult to remove:
1. Place saw on a hard flat
surface.
2. Press battery latch and
push bottom of battery
against the hard surface.
3. Slide battery out of saw.
Hanging and Lifting
Hooks
Hanging Hook (A):
Attach a rope or carabiner to
prevent accidental dropping
of saw while working in a
tree.
Lifting Hook (B):
Use to hook and unhook from
harness in one quick
movement.
OPERATION
Starting the Unit
When starting the unit, observe the precautions described in the
section "For safe use of your product" to ensure that you
operate the product correctly. Failure to do so might cause
serious personal injury.
A
C
B