Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500T Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- One-handed use is intended for trained tree service professionals only.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
ASSEMBLY DCS-2500T
30 X7508220201
© 4/22 ECHO Incorporated
5. Mount guide bar (E) and slide
toward sprocket (F) to make
saw chain installation easier.
6. Install saw chain as shown.
(Ensure cutters are pointing in
the right direction.)
7. Install the sprocket cover over
the guide bar stud. Ensure that
chain tension adjuster (G) fits
into guide bar hole.
8. Tighten sprocket cover nut
finger tight.
9. Hold the guide bar nose up and
turn the adjuster (H) clockwise
until the chain fits snugly
against the underside of the
bar.
10. Tighten sprocket cover nut with
bar nose held up.
11. Pull the chain around the guide
bar by hand. Loosen the
adjustment if you feel tight
spots.
E
F
C
G
H