Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500T Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- One-handed use is intended for trained tree service professionals only.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
DCS-2500T ASSEMBLY
X7508220201 29
© 4/22 ECHO Incorporated
All adjustments should be made cold. Always wear gloves when
working on a saw chain. Do not operate with a loose chain.
Otherwise personal injury might result.
Note: Move the chain brake lever (Front hand guard) fully rearward
to remove or install the guide bar cover to the chain saw.
1. Release chain brake (A).
2. Loosen sprocket cover nut (B).
3. Remove sprocket cover (C).
4. Install spiked bumper (D).
Secure with 2 bolts.
C
A
B
C
C
D