Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500T Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- One-handed use is intended for trained tree service professionals only.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
SAFETY DCS-2500T
18 X7508220201
© 4/22 ECHO Incorporated
• Cutting at high speeds may reduce the likelihood of kickback. But cutting
at part-throttle or low speeds may be preferable to control the chainsaw in
tight situations and may also reduce the likelihood of kickback.
General Precautions
Operator’s Manual
Be careful to read the operator's manual properly before
using your product in order to ensure correct operation.
Failure to do so could lead to an accident or serious injury.
Do not use the product for anything other than its intended
purpose.
You must not use the product for any purpose other than those described
in the operator’s manual. To do so could lead to an accident or serious
injury.
Do not modify the product
You must not modify the product. To do so could lead to an accident or
serious injury. Any malfunction resulting from a modification to the product
will not be covered by the manufacturer's warranty.
Do not use the product unless it has been checked and
maintained
You must not use the product unless it has been checked and maintained.
Always ensure that the product is checked and maintained on a regular
basis. Failure to do so could lead to an accident or serious injury.
Loaning or assigning your product
• When loaning your product to another party, ensure that the person
borrowing the product receives the operator's manual along with it.
• If you assign your product to another party, please enclose the operator's
manual with the product when handing it over. Failure to do so could lead
to an accident or serious injury.
Being prepared in case of an injury
In the unlikely event of an accident or injury, please ensure that you are
prepared.