Use and Care Manual

5
CS-800P
PACKING LIST
The ECHO product you purchased has been
factory pre-assembled for your convenience.
Due to packaging restrictions, guide bar and saw
chain installation and other assembly may be
necessary.
After opening the carton, check for damage.
Immediately notify your retailer or ECHO dealer of
damaged or missing parts.
Use the packing list to check for missing parts.
DECALS
Locate this safety decal on your unit. The complete
unit illustration found in the “NOMENCLATURE OF
PARTS” section will help you locate them.
Make sure the decal is legible and that you
understand and follow the instructions on it. If a
decal cannot be read, a new one can be ordered
from your ECHO dealer.
13 x 19 mm T-wrench
Operator's manual
ECHO chain saw
Saw chain
Guide bar
Warranty sheet
• •
• •
• •
• •
• •
Part Number X505-009760
Spiked bumpers, Bolts 6 × 14 mm,
Bolts 6 × 20 mm, Washers 6 mm, Nuts 6 mm
Part Number X505-009380
Chain brake must be unlocked before removing or installing clutch cover. Improper
cover installation can result in serious injury and cause severe damage to saw.
El freno de cadena debe ser desbloqueado antes de remover o de instalar la cubierta del
embrague. La instalación incorrecta de la cubierta puede dar lugar a una lesión seria y
causar daño a la sierra.
Le frein de chaîne doit être désengagé avant d’enlever ou d’installer le couvercle
d’embrayage. Un couvercle d’embrayage installé incorrectement pent avoir de
conséquences grave menant à des blessures et/ou des dommages à la scie a chaîne.
WARNING