Use and Care Manual
Table Of Contents
- Operator’s Manual CS-7310P Chainsaw
- Table of Contents
- Introduction
- Servicing Information
- Packing List
- Safety
- Emission Control
- (Exhaust & Evaporative)
- Description
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
OPERATION CS-7310P
32 X7503340002
© 11/21 ECHO Incorporated
Note: If engine does not start after 5 pulls, repeat instructions.
◆ After starting the engine, immediately squeeze and then
release throttle trigger to release fast idle throttle latch,
otherwise severe brake damage can occur.
◆ Never use fast idle throttle latch for cutting.
◆ Use the fast idle throttle latch only in starting.
Note: Do not increase engine speed while chain brake is locked.
Severe brake damage will result.
Starting Warm Engine
Make sure the bar and chain are free from any obstruction when
starting the chainsaw.
1. Move chain brake lever fully
FORWARD to LOCK chain
brake before starting.
2. Confirm there is fuel and chain
oil in the tanks.
3. Move stop switch (A) UP to
“RUN” position.
A