Use and Care Manual

DESCRIPTION CS-7310P
22 X7503340000
© 10/20 ECHO Incorporated
Preparation For Use
Saw chain is sharp! Always wear gloves when handling
assembly, otherwise serious personal injury can result.
Guide Bar and Saw Chain Installation / Removal
1. Remove air cleaner cover and disconnect spark plug lead.
When removing sprocket guard,
loosen each nut one full turn, then
completely loosen each nut. If one
nut remains tight while the other is
fully loosened, nut will not remain
captive
2. Loosen sprocket guard nuts (A)
and remove sprocket guard (B).
3. Remove guide bar and saw
chain if necessary.
Note: See “Maintenance” section
for guide bar / saw chain
maintenance procedures.
4. For initial setup, install spiked
bumpers. Bumper with chain
catcher (C) onto front of chain
saw body, and bumper without
chain catcher (D) onto clutch
cover.
B
A
A
C
D