Use and Care Manual
Table Of Contents
- Operator’s Manual CS-4910 Chainsaw
- Table of Contents
- Introduction
- Servicing Information
- Safety
- Emission Control
- (Exhaust & Evaporative)
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
CS-4910 OPERATION
X7503314201 31
© 05/22 ECHO Incorporated
◆ After choke control knob is pulled and then knob is
returned to original position, throttle remains slightly open
(fast idle latch condition).
◆ The chain will attempt to move when engine is started with
fast idle throttle latch engaged.
◆ Do not start engine before chain brake is locked.
Note: Do not squeeze throttle trigger until after chainsaw starts.
7. Securely hold the chainsaw and
pull starter handle (E) several
times until first starting sound.
8. Push choke control knob (C) all
the way IN (OPEN choke
position).
9. Press the decompression device
(D).
10. Pull starter handle (E) to start the
engine.
Note: Do not pull starter rope out
to the maximum possible
position. Do not allow starter handle to snap back against the
casing. If engine does not start after five pulls, repeat
instructions.
◆ After starting the engine, immediately squeeze and then
release throttle trigger to release fast idle throttle latch,
otherwise severe brake damage may occur.
◆ Never use fast idle throttle latch for cutting.
◆ Use the fast idle throttle latch only in starting.
E