Use and Care Manual

Table Of Contents
CS-4910 ASSEMBLY
X7503314201 23
© 05/22 ECHO Incorporated
Instructions to Install Optional Kick Guard
TM
to Bar
Tools needed: two 11 mm (7/16 in.)
wrenches.
1. Install bolt (A) in rear hole (B) of
optional Kick Guard
TM
and
through front hole (C) in guide
bar.
2. IMPORTANT: Dimple (D) in
optional Kick Guard
TM
must
engage recess (E) in guide bar.
3. Securely tighten nut (F) and
bolt (A).
Guide Bar and Saw Chain Installation / Removal
1. Disconnect spark plug lead.
2. Unlock chain brake (A).
3. Remove sprocket guard nuts
(B) and remove sprocket guard
(C).
4. Remove guide bar (D) and saw
chain (E) as necessary.
Note: See “Maintenance”
section for guide bar /
saw chain maintenance
procedures.
A
B
C
D
E
F
A
B
C
C
G
B
ED
H
F