Use and Care Manual

30
CS-4510
CYLINDER FINS
• Check daily or before use.
• Clogged fins will result in poor engine cooling.
• Remove the air cleaner cover and the air filter,
and the spark plug lead.
• Remove the three bolts of the cylinder cover.
• Loosen the two mounting bolts of the cleaner
case.
• Lift the cylinder cover up to the cushion of the
cleaner case and pull it out.
• Remove dirt and dust from between fins to let
cooling air pass easily.
• Assemble the components in reverse order.
• Do not forget to fasten the two loose bolts of
the cleaner case.
MUFFLER SPARK ARRESTOR
• Remove the clutch cover and pull the front hand
guard backwards.
• Remove the spark arrester screen bolt and pull
out the screen from the silencer body.
• Clean carbon deposits from muffler components.
• Replace screen if it is cracked, or has holes
burned through.
• Assemble components in reverse order.
NOTICE
Carbon deposits in muffler will cause drop in
engine output. The spark arrestor screen must
be checked periodically.
AUTOMATIC OILER
• The discharge volume of the automatic oiler is
adjusted to 7 mL/min approximately at 7,000
r/min, prior to shipment from factory.
- To increase the delivery volume, turn the
adjusting screw counterclockwise.
When the screw touches stopper and stops,
this position indicates maximum discharge
volume. (13 mL/min at 7,000 r/min)
- Do not turn the adjusting screw beyond the
maximum or minimum limit of volume
adjustment.
Cylinder fins
Spark arrestor screen
Muffler
Bolt
DecreaseIncrease
Adjusting screw
Cylinder cover
Cushion
Three bolts
Cylinder cover
Spark plug
Front hand guard
Cleaner case
Two bolts
Cushion
Cleaner case