Use and Care Manual

28
CS-4510
0.65 mm (0.026 in.)
Cleaner cover latch
Air filter
Air cleaner cover
AIR FILTER
• Check before every use.
• Close choke ( ).
• Release the cleaner cover latch.
• Pull air cleaner cover back and up to remove.
• Remove the air filter by turning it
counterclockwise.
• Brush off dust lightly, or clean with compressed
air, or replace the air filter.
• Install air filter by turning it clockwise. Arrow on
filter will point up when filter is correctly installed.
• Install air cleaner cover and engage cleaner
cover latch.
CHECK FUEL SYSTEM
• Check before every use.
• After refueling, make sure fuel does not leak
from around fuel pipe, fuel grommet or fuel tank
cap.
• In case of fuel leakage there is a danger of fire.
Stop using the machine immediately and request
your dealer to inspect or replace.
SPARK PLUG
• Remove air cleaner cover.
• Remove spark plug lead.
• Remove spark plug.
• Check periodically.
• The standard spark gap is 0.65 mm
(0.026 in.).
• Correct the spark gap if it is wider or narrower
than the standard gap.
• Fastening torque: 15 to 17 N·m
(130 to 145 in. lb.).
Air cleaner cover
Arrow
Spark plug lead