Use and Care Manual

18
CS-4510
Chain brake
Starter handle
Throttle trigger
Choke
Throttle trigger lockout
Purge pump
Chain brake
Starter handle
WHEN THE ENGINE IS COLD
CAUTION
Make sure the bar and chain are free from
any obstruction when starting the chain saw.
• Move chain brake lever fully forward to lock
chain brake before starting.
• Fill the fuel tank with fuel mixture.
It is not permitted to fill fuel above the shoulder
level of fuel tank.
• Fill the chain oil tank with lubricant.
Do not over fill.
• Pull choke control knob all the way out.
(Choke position )
• Push purge pump 3 to 4 times or until fuel is vis-
ible in purge pump.
• Securely hold the chain saw as shown and
pull starter handle several times until first firing
sound.
• Push choke control knob all the way in.
• Pull starter handle again to start the engine.
• When engine starts, immediately squeeze and
release throttle trigger to release fast idle throttle
latch otherwise severe brake damage may occur.
WHEN THE ENGINE IS WARM
CAUTION
Make sure the bar and chain are free from
any obstruction when starting the chain saw.
• Move chain brake lever fully forward to lock
chain brake before starting.
• Confirm there is fuel and chain oil in the tanks.
• Securely hold the chain saw as shown and pull
starter handle.
• Choke may be used if necessary, but after first
firing sound, squeeze and release throttle trigger
to release fast idle throttle latch otherwise severe
brake damage may occur.