Owner's Manual

30
CS-400F
NOTE
These angles are referred to as 91PX. To sharp-
en other chains, follow chain manufacturer’s
instructions.
• Place the depth gauge tool rmly on guide bar so
that depth gauge protrudes. Then le top of depth
gauge with the at le until at with top of the depth
gauge tool.
• Be sure to round off the front edge of the depth
gauge.
Properly led cutters are shown in illustration.
When setting of the chain is nished, soak it in oil
and wash away lings completely before using.
• When chain has been led on the bar, supply suf-
cient oil to it, move the chain slowly to wash away
the lings before using again.
• If the chain saw is operated with lings clogged in
the groove, the saw chain and the guide bar will be
damaged prematurely.
• If the saw chain becomes soiled with resin, for
instance, clean it with kerosene and soak in it oil.
Top plate ling angle
30°
Parallel
0.64 mm (0.025 in.)
Depth gauge
Remove until
at with tool
Depth gauge tool
Round off
the edge
1/5
One fth of le diameter remains
above cutter edge
Side plate angle
80°