Use and Care Manual

MAINTENANCE CS-400

46 X7503255901

Automatic Oiler

• The discharge volume of the

automatic oiler is adjusted to

approximately 4 mL/min at 7000 r/

min, prior to shipment from factory.

• Always check oil discharge when in

use.

• Turn adjusting screw (A)

counterclockwise to increase oil volume, clockwise to decrease oil

volume.

• Do not turn the adjusting screw beyond the maximum or minimum limit of

volume adjustment.

Oil Filter

• Check periodically.

• Do not allow dust to enter into oil

tank.

• A clogged oil filter (B) will affect the

normal lubricating system.

1. Pull filter out through oil port, and

inspect filter.

2. If the filter is dirty, wash it in gasoline or replace it as follows:

a. Do not remove the wire coil clamp to remove the filter. Pinch the

filter with the fingers on one hand and the line with the other hand.

Pull and twist slightly to separate.

b. Install the new filter with the reverse action.

3. When the inside of the tank gets dirty, rinse the tank out with gasoline

to clean it.

Guide Bar

1. Clean before using.

2. Clean the groove of the guide bar

(A) with a small screwdriver.

3. Clean oil holes (B) with a wire.

4. Invert guide bar periodically.

5. Clean the guide bar mount area

before installing the guide bar.

Decrease

Increase