Use and Care Manual

OPERATION CS-400
32 X7503255901
© 06/2019 ECHO Inc.
1. Move chain brake lever fully
FORWARD to LOCK chain brake
before starting.
2. Confirm there is fuel and chain
oil in the tanks.
3. Move ignition switch (A) UP to
“RUN” position.
4. Securely hold the chain saw as
shown and pull starter handle.
5. Choke may be used if necessary,
but after first starting sound,
squeeze throttle trigger to
release choke and return engine
to idle.
Note: If engine does not start
after 5 pulls, use cold start
procedure.
Note: Do not increase engine
speed while chain brake is
locked. Severe brake damage will result.
Chain brake
A