Instructions / Assembly

X7503255900 7

CS-400 SAFETY

If the chain does not stop immediately, return the saw to your

authorized dealer for repair.

Note:

• For practice, while cutting a small tree, push the lever forward to lock the

brake.

• Confirm that the brake works properly before each use.

• If the chain brake is clogged with wood chips, function of the brake may

deteriorate. Always keep the device clean.

• Do not increase engine RPM's while the chain brake is locked.

The installation of a chain brake may be mandatory by law or as stipulated by

insurance regulations in your area of operation. You should inquire through local

government offices, your employer or your local dealer to ensure that your chain

saw conforms to the required safety standard.

Chain brakes have been designed and tested to comply with international safety

standards as follows.

USA: ANSI Standard B175.1 Safety Requirement for chain saws

ANSI Standard B175.1 stipulates that the brake shall stop the chain

0.12 seconds at an engine speed of 13,500 r/min. It is the

responsibility of the owner/operator to ensure that the brake is

serviced, adjusted and tested strictly in accordance with the

instructions as detailed here in order to ensure that the brake

performance is maintained in compliance with the Standard

B175.1.