Instructions / Assembly

MAINTENANCE CS-400

40 X7503255900

2. When the filter is dirty, replace it.

3. When the inside of the fuel tank is dirty, rinse the tank out with gasoline to

clean it.

Note: Federal EPA regulations require all model year 2012 and later

gasoline powered engines produced for sale in the United States

to be equipped with a special low permeation fuel supply hose

between the carburetor and fuel tank. When servicing model

year 2012 and later equipment, only fuel supply hoses certified

by EPA can be used to replace the original equipment supply

hose. Fines up to $37,500 may be enforced for using an un-

certified replacement part.

Automatic Oiler

• The discharge volume of the automatic

oiler is adjusted to approximately 4 mL/

min at 7000 r/min, prior to shipment

from factory.

• Always check oil discharge when in

use.

• Turn adjusting screw (A)

counterclockwise to increase oil

volume, clockwise to decrease oil

volume.

• Do not turn the adjusting screw beyond the maximum or minimum limit of

volume adjustment.

Oil Filter

• Check periodically.

• Do not allow dust to enter into oil tank.

• A clogged oil filter (B) will affect the

normal lubricating system.

1. Pull filter out through oil port, and

inspect filter.

2. If the filter is dirty, wash it in gasoline

or replace it.

3. When the inside of the tank gets dirty, rinse the tank out with gasoline to

clean it.

Decrease

Increase