Instructions / Assembly

X7503255900 35

CS-400 OPERATION

Only use saw chain designated as, “LOW-KICKBACK,” that meets

ANSI B175.1 or CSA Z62.1, .3 Standard when tested on the

representative sample of chain saws below 3.8 C.I.D., and Echo

guide bar specified.

Chain and guide bar gauge size must be identical. Use Bar/Chain

combinations shown in table above.

If your tip guard is damaged or lost, contact your Echo dealer for a

replacement. For the name of the Echo dealer nearest you, Call: 1-800-

432-ECHO (3246) or on the web at www.echo-usa.com

Refer to your Chain Saw Safety Manual for tip guard application information.

Guide Bar

(Low-kickback)

Replacement guide bars.

The following guide bars may be considered to have equivalent kickback

energy.

• Sprocket nose guide bars of the same length and nose radius, same pitch

and having the same number of teeth.

• Hard nose guide bars of the same length and nose radius as a sprocket nose

bar.

Saw Chain

(Low-kickback)

Do not use replacement saw chain unless it has been designated

as meeting ANSI B175.1 or CSA Z62.1, .3 kickback performance

requirements, when tested on the representative sample of chain

saws below 3.8 c.i.d. specified in ANSI B175.1 or CSA 62.1, .3.

Note: LOW KICKBACK SAW CHAIN meets the kickback performance

requirements of ANSI B175.1 or CSA 62.1, .3 (safety

requirements for gasoline-powered chain saws).