Instructions / Assembly

X7503255900 21

CS-400 DESCRIPTION

6. Install sprocket guard over guide bar

studs. Ensure chain tension adjuster

pin (H) fits into the guide bar adjuster

hole (G), brake band (J) is positioned

around clutch drum. Tighten

sprocket guard nuts finger tight.

7. Turn saw over, and check brake band

(J) for correct position on clutch

drum. If brake band is not in place

around drum, remove sprocket

guard, and reinstall. Tighten sprocket

guard nuts finger tight.

8. Adjust saw chain tension, as

instructed in “Adjustment, Chain

Te ns ion ”.

Improper sprocket guard assembly can result in serious injury, and

will cause severe saw damage if unit is started. Never start or

operate saw if brake band is not in place on clutch drum. Always

check chain brake operation after replacing guard. Do not use saw

if chain brake does not function properly.

Adjusting Chain Tension

Always loosen sprocket guard nuts before turning the

chain tension adjuster, otherwise the sprocket guard and

tensioner will be damaged.