Instructions / Assembly

X7503255900 19

CS-400 DESCRIPTION

22. OIL TANK CAP - For sealing the oil tank.

23. FRONT HANDLE - FOR THE LEFT HAND - Support handle located at the

front of the engine housing.

24. CYLINDER COVER - The cooling airflow grill. It covers the cylinder, spark

plug and silencer.

CHAIN SAW TERMS

1. FAST IDLE -Throttle setting that causes engine to operate at a faster

speed for easier starting.

2. THROTTLE LATCH - Device that sets idle speed to fast idle when choke

control is operated.

3. CHAIN BRAKE - Stops the saw chain.

4. DRIVE SPROCKET - Drives saw chain.

5. CLUTCH - Turns drive sprocket when engine rpm is fast enough to provide

the power needed for cutting.

Preparation For Use

Saw chain is sharp! Always wear gloves when handling assembly,

otherwise serious personal injury may result.

Note: The machine may be delivered with guide bar, tip

guard, and saw chain separated. Install guide

bar, tip guard, and saw chain as follows.

Tip Guard to Bar Instructions

Tools Needed: Two 11 mm (7/16 in.)

Wrenches. For saws with tip guard P/N

2893201 and Symmetrical or

Asymmetrical Low-Kick type (Double

Guard) guide bars.

1. Install bolt (A) in rear hole (B) of tip

guard and through front hole (C) in

guide bar.

2. IMPORTANT: Dimple (D) in tip guard

must engage recess (E) in guide bar.

3. Securely tighten nut (F) and bolt (A).