Use and Care Manual

17
CS-352
WARNING
• After choke control knob is pulled and
then knob is returned to original position,
throttle remains a little open (latch
condition).
• If engine is started in this latch condition,
chain starts to turn. Do not start engine
before chain brake is activated.
CAUTION
• After starting the engine, squeeze throttle
trigger slightly to release throttle latch and
pull front hand guard towards the operator
immediately.
(Chain brake unlocked position)
• Never use throttle latch for cutting.
Start / Run
Ignition switch
Chain brake
Starter handle
Choke
Choke control knob
Purge pump
WHEN THE ENGINE IS COLD
CAUTION
Make sure the bar and chain are free from
any obstruction when starting the chain saw.
• Move chain brake lever fully forward to lock
chain brake before starting.
• Fill the fuel tank with fuel mixture.
It is not permitted to ll fuel above the shoulder
level of fuel tank.
• Fill the chain oil tank with lubricant.
Do not over ll.
• Move ignition switch to “RUN” position.
• Push purge pump 3 to 4 times or until fuel is vis-
ible in purge pump.
• Pull choke control knob all the way out. (Choke
position)
• Securely hold the chain saw as shown and
pull starter handle several times until rst ring
sound.
• Push choke control knob all the way in.
• Pull starter handle to start the engine.
• When engine starts, immediately squeeze throt-
tle trigger, to release throttle latch.
Start / Run
Ignition switch
Chain brake
Starter handle
Choke
Choke control knob
Purge pump