Operator's Manual
Table Of Contents
- Operator’s Manual CS-3510 CHAIN SAW
- Table of Contents
 - Introduction
 - Servicing Information
 - Packing List
 - Safety
 - Emission Control
 - (Exhaust & Evaporative)
 - Description
 - Operation
 - Maintenance
 - Troubleshooting
 - Storage
 - Specifications
 - Notes
 - Product Registration
 
 
CS-3510 TROUBLESHOOTING
X7503360201 53
© 8/20 ECHO Incorporated
TROUBLESHOOTING
ENGINE PROBLEM TROUBLESHOOTING CHART
Problem Check Status Cause Remedy
Engine 
starts hard
or
Engine
does not 
start
Fuel at 
carburetor
No fuel at 
carburetor
Fuel strainer or 
fuel line 
obstructed
Clean or replace
See your dealer
Fuel at 
cylinder
No fuel at 
cylinder
Carburetor See your dealer
Engine 
starts hard
or
Engine
does not 
start
Muffler wet 
with fuel
Fuel mixture too 
rich
OPEN choke
Clean or replace 
air filter
Adjust carburetor
See your dealer
Spark at 
end of plug 
wire
No spark
Incorrect gap - 
Covered with 
carbon - Fouled 
with fuel - Plug 
defective
Adjust to 0.65mm 
(0.026 in.)
Clean or replace 
plug
Spark at 
plug
Engine 
runs, but 
dies 
or 
Engine 
does not 
accelerate 
properly
Air filter Air filter dirty Normal wear Clean or replace
Fuel filter
Fuel filter 
dirty
Contaminants 
or residue in fuel
Replace filter or 
replace fuel
Fuel vent
Fuel vent 
plugged
Contaminated 
fuel
Clean or replace
Engine 
runs, but 
dies 
or 
Engine 
does not 
accelerate 
properly
Spark plug
Plug dirty or 
worn
Normal wear
Clean and adjust 
or replace
Carburetor
Improper 
adjustment
Vibration Adjust
Cooling 
system
Cooling 
system dirty 
or plugged
Extended 
operation in 
dirty or dusty 
locations
Clean
Spark 
arrestor 
screen
Spark 
arrestor 
screen 
plugged 
Normal wear Replace










