Operator's Manual
Table Of Contents
- Operator’s Manual CS-3510 CHAIN SAW
- Table of Contents
 - Introduction
 - Servicing Information
 - Packing List
 - Safety
 - Emission Control
 - (Exhaust & Evaporative)
 - Description
 - Operation
 - Maintenance
 - Troubleshooting
 - Storage
 - Specifications
 - Notes
 - Product Registration
 
 
CS-3510 MAINTENANCE
X7503360201 43
© 8/20 ECHO Incorporated
IMPORTANT NOTE - Time intervals shown are maximum. Actual use and 
your experience will determine the frequency of required maintenance.
MAINTENANCE PROCEDURE NOTES: 
1 Low evaporative fuel tanks DO NOT require regular maintenance to 
maintain emission integrity.
2 Model dependent
* Replacement is recommended based on the finding of damage or wear 
during inspection.
Guide Bar & Sprocket Nose Inspect / Clean * 1
Saw Chain Inspect / Sharpen / Replace / 
Tensioning *
2
Sprocket Inspect / Replace * 2
Cooling System Inspect / Clean 2
Recoil Starter Rope Inspect / Clean * 1
Screws / Nuts / Bolts Inspect / Tighten / Replace * 1
Lifting Hook Inspect
2
1
Every Refuel
Fuel System Inspect 
1
1
Guide Bar & Sprocket Nose Inspect 1
3 Months
Air Filter Replace * 1
Oil Filter Inspect / Replace * 1
Fuel Filter Inspect * 1
Fuel Cap Gasket Inspect * 1
Spark Plug Inspect / Clean / Replace * 1
Muffler Spark Arrestor Inspect/Clean/Replace * 2
Cylinder Exhaust Port Inspect / Clean / De-carbon 2
Yearly
Fuel Filter Inspect / Replace * 1
Fuel Cap Gasket Replace * 1
Component / System Maintenance Procedure
Req’d 
Skill 
Level










