Use and Care Manual

ManualsBrandsECHO ManualsChainsaws12 in. 30.1 cc Gas 2-Stroke Cycle Chainsaw

BEFORE MAKING ADJUSTMENTS:

• The correct spark plug must be clean and properly

gapped.

• The air lter element must be clean and properly

installed.

• The mufer spark arrestor screen and exhaust port

must be clear of carbon.

• The standard bar and chain combination must be

installed to the power head, and properly tensioned.

LOW ALTITUDE ADJUSTMENT

Engines that have been adjusted to operate at high alti-

tudes must be readjusted to operate properly at altitudes

below 2000 feet.

1. Start engine and run for several minutes to reach

operating temperature.

2. Stop engine. Remove grommet cover (A) over “H”

and “L” limiter needles.

3. Start engine and turn the high-speed needle rich

(CCW) until the engine runs between 11,500 and

12,000 RPM. Then turn the low-speed needle rich

(CCW) until the engine does not hesitate when ac-

celerated.

DO NOT REMOVE LIMITER CAPS!

4. Idle Speed Adjustment.

• Turn “idle” speed adjustment screw (B) CW until

the saw chain begins to move, then turn the screw

CCW until saw chain stops moving. Turn screw

CCW an additional 1/4 turn.

5. Accelerate to full throttle for 2-3 seconds to clear ex-

cess fuel from engine then return to idle. Accelerate

to full throttle to check for smooth transition from idle

to full throttle. If engine stops or stalls after full warm

up return the unit to your authorized ECHO dealer

for adjustment.

6. Install grommet cover (A) over “H” and “L” limiter

needles.

HIGH ALTITUDE ADJUSTMENT

High altitude adjustment may be required for proper

operation of this engine above 2000 feet.