Use and Care Manual
Table Of Contents
- Operator’s Manual CS-2511P Chain Saw
- Table of Contents
- Introduction
- Servicing Information
- Packing List
- Safety
- Emission Control
- Emission Control (Exhaust & Evaporative)
- Description
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
OPERATION CS-2511P
32 X7503333700
© 11/2020 ECHO Incorporated
4. Move STOP switch (B) to RUN
position.
5. Press purge bulb (C) 8 times or
until fuel is visible in the purge
bulb.
6. Turn choke control knob (D)
counterclockwise to (CLOSED
choke position).
◆ After choke control knob is turned and the knob returned
to original position, throttle will remain slightly open (latch
condition).
◆ The chain will attempt to move when engine is started with
fast idle throttle latch engaged.
◆ Do not start engine before chain brake is locked.
7. Securely hold the chain saw
and pull starter handle (E)
several times until first starting
sound.
Note: Do not pull starter rope
out to the maximum
possible position. Do not
allow starter handle to
snap back against the
casing. If engine does
not start after 5 pulls, repeat instructions.
B
C
D
E