Use and Care Manual

Table Of Contents

DESCRIPTION CS-2511P

22 X7503333700

Preparation For Use

Make sure engine is stopped before performing any of the

procedures that follow. Saw chain is sharp! Always wear gloves

when handling assembly. Failure to follow instructions can

cause serious personal injury.

Note: The machine may be delivered with guide bar, and saw chain

not installed. Install guide bar, saw chain, and optional Kick

Guard

as follows.

Instructions to Install Optional Kick Guard

to Bar

Tools Needed: Two 11 mm (7/16 in.)

Wrenches.

1. Install bolt (A) in rear hole (B) of

optional Kick Guard

and

through front hole (C) in guide

bar.

2. IMPORTANT:

Dimple (D) in

optional Kick Guard

must

engage recess (E) in guide bar.

3. Securely tighten nut (F) and

bolt (A).

Guide Bar and Saw Chain

Installation / Removal

1. Use T-Wrench to open air

cleaner cover latch. Disconnect

spark plug lead.

2. Unlock chain brake (A).

3. Remove sprocket guard nut (B)

and remove sprocket guard

cover (C).

Optional

Kick Guard