Manual

SERVICE INFORMATION
CLS-5000
CLS-5010
2
1 SERVICE INFORMATION
1-1 Specifications
Model CLS-5000 CLS-5010
Dimensions Length* mm(in) 1735 (68.3) 1875 (73.8)
Width mm(in)
700 (25.6) (other than Canada)
650 (25.6)
630 (24.8) (Canada)
Height mm(in) 475 (18.7) 535 (21.1)
Dry weight* kg(lb) 9.8 (21.61) 10.3 (22.71)
Engine Type
KIORITZ, air-cooled, two-stroke, single cylinder
Semi-automatic decompression
Rotation Counterclockwise as viewed from the output end
Displacement cm
3
(in
3
) 51.7 (3.155)
Bore mm(in) 44.0 (1.732)
Stroke mm(in) 34.0 (1.339)
Compression ratio 6.6
Carburetor Type Diaphragm, horizontal-draught, with primer
Model Walbro
WYK-172 (other than Canada) Walbro WYK-172
WYK-173 (Canada)
Venturi size-Throttle bore mm(in) 13.5 - 15.0 (0.531 - 0.591)
Ignition Type
CDI (Capacitor discharge ignition) system
in a single integrated piece, with electronic timing advancer
Spark plug RCJ-6Y
Starter Type Automatic rewind
Rope diameter x length mm(in) 3.8 x 1150 (0.15 x 45.3)
Fuel Type Premixed two-stroke fuel (Refer to Operator’s manual.)
Tank capacity L (U.S.fl.oz.) 1.0 (33.8)
Clutch Type Centrifugal, 2 - shoe pivot
Handle Type Front U-shaped adjustable, with integrated control grip
Drive shaft Type Solid
Diameter - Length mm(in) 10.0 - 1448 (0.39 - 57.0) 10.0 - 1578 (0.39 - 62.1)
Housing OD -ID mm(in) 35 - 31.8 (1.38 -1.25) 35 - 31.8 (1.38 -1.25)
(Main pipe) Length mm(in) 1400 (55.1) 1530 (60.2)
Gear case Reduction ratio 1.4
Gear tooth Spiral bevel gear
Lubrication Lithium based grease
Cutter Type Nylon line cutter, chipper saw
Pilot diameter mm(in) 20.0 (0.79)
Fastener type, size mm Left-hand thread nut, M12 x 1.75 pitch
Cutting rotation Counterclockwise as viewed from top
OD: Outer diameter.
ID: Inner diameter.
* Without shoulder harness and cutter head.