Use and Care Manual

MAINTENANCE BRD-2620
36 X7502343000
© 8/2017 ECHO Inc.
Note: Every unit is run at the
factory and the carburetor
is set in compliance with
emission regulations.
Carburetor adjustments,
other than idle speed,
must be performed by an
authorized dealer.
1. Check idle speed and reset if
necessary. If a tachometer is
available, idle speed screw (A)
should be set to the
specifications found on
“Specifications” page of this
manual. Turn idle screw (A)
clockwise to increase idle speed; counterclockwise to decrease idle
speed.
Drive Shaft Lubrication
Level 1.
1. Loosen two (2) screws (A) and
remove center locating screw
(B). Pull gear box and shield
from drive shaft housing.
2. Pull flexible cable from the drive
shaft housing, wipe clean and
re-coat with a thin coating (15
ml [½ oz.]) of grease.
3. Slide the flexible cable back in
the drive housing. DO NOT get
dirt on the flex cable.
4. Install the gear housing and
shield assembly.
5. Tighten screws securely.
Parts Required: Lithium Based Grease.
A
A
A
A
B