Use and Care Manual

ManualsBrandsECHO ManualsEdgers25.4cc Gas 2-Stroke Engine Bed Redefiner

BRD-2620 OPERATION

X7502343000 27

© 8/2017 ECHO Inc.

ENGLISH

4. Loosen blade adjustment knob

and adjust the blade’s depth of

cut to produce a fine cut

between sidewalk and grass

using a minimum blade depth,

usually with about 13 mm (0.5

in.) of the blade into the ground.

Tighten adjustment knob.

5. Before edging, plan your direc-

tion of travel so that the unit will

always be on your right side

and so that you walk on a hard

surface whenever possible.

6. Position edger as shown.

7. When starting to work, run the

engine at full throttle, and lower

the blade gently into the

ground. Travel around

perimeter of bed, allowing the

Redefiner to improve bed's

edge.

Use the blade location slot in the top of the debris shield as a guide

to align the blade with the cut during edging.

8. Do not force the blade. Move

only as quickly as the blade will

allow.

Increase

depth.

Decrease

depth.

Adjustment

Knob

Wheel