Use and Care Manual

EMISSION CONTROL BRD-2620

12 X7502343000

Moving parts can amputate fingers or cause severe injuries.

Keep hands, clothing and loose objects away from all openings.

◆ ALWAYS stop engine, disconnect spark plug, and make

sure all moving parts have come to a complete stop before

removing obstructions, clearing debris, or servicing unit.

◆ DO NOT start or operate unit unless all guards and

protective covers are properly assembled to unit.

◆ NEVER reach into any opening while the engine is running.

Moving parts may not be visible through openings.

Periodically Check fuel system (fuel lines, vent, grommet,

fuel tank, and fuel cap) for leaks especially if the unit is

dropped. If damage or leaks are found, do not use unit,

otherwise serious personal injury or property damage

may occur. Have unit repaired by an authorized servicing

dealer before using

EMISSION CONTROL (EXHAUST &

EVAPORATIVE)

CARB And EPA Emissions Control Information

The emission control system for the

engine is EM (engine modification)

and, if the second to last character

of the Engine Family on the

Emission Control Information label

(sample below) is “B”, “C”, “K”, or

“T”, the emission control system is

EM and TWC (3-way catalyst). The

fuel tank/fuel line emission control

system is EVAP (evaporative emissions). Evaporative emissions for

California models are only applicable to fuel tanks.