Instructions / Assembly

- 3 -

X7672230407

SRM’s with 2-screw front handles:

1. Position the front handle on the driveshaft and

install the barrier bar using two 5 x 35 mm

screws provided in the kit. The handle must be

at least 250 mm (10 in.) from the center of the

rear handle grip.

2. Adjust the handle position for comfortable oper-

ation, and tighten the screws securely.

Note: The barrier bar is not a handle.

Install the Shield and Gear Case Assembly

1. Install the gear case assembly on the end of

driveshaft taking care to engage the drive cable

with the gear case.

2. Align the gear case on the driveshaft and install

locating screw (N).

3. Tighten the two side clamping screws (M).

IMPORTANT: The at edge of washers (O) must be

against the driveshaft.

Install Plastic Blade Shield

Tools Required: Torx T27 L-Wrench

Parts Required:

• 3 - 5 x 25 mm screws (plastic shield to gear

case)

• 3 - 5 mm lock nuts

1. If installed remove the nylon line head, upper

xing plate, shield plate, and plastic shield.

2. Align the locking hole in the upper plate with the

notch in the edge of the gear housing and insert

head locking tool (A).

3. Remove line head (B) by turning it clockwise

until the head is completely off the driveshaft.

4. Remove the locking tool.

5. Remove the three screws holding the shield

plate and plastic shield (C) to the gear case.

6. Retain all parts for conversion back to nylon line

head operation.