Owners Manual v.3 User guide

4 INCH CHIPPER
19
ENGLISH
Section
TROUBLESHOOTING
6
PROBLEM POSSIBLE CAUSES REMEDY

Improper control settings. 
 
Spark plug disconnected. Connect spark plug.
 
Internal engine problems. 

stops.
Obstructed discharge. 
Plugged rotor. 
Feeding material too large into
shredder.

Chipper does not chip.
Dull chipper blades. Rotate or sharpen blades.
Drive belts loose or worn. 

are too large.


blades
Replace blade.

 
Improper oil level. 


to chip.
Dull chipper blades. Reverse or sharpen blades.
Obstructed discharge. 
Improper blade clearance. 


clutch.
 
Plugged rotor. 
 Replace belt or spring.



chipper blades.

Dull chipper blades. Sharpen blades.
Improper blade clearance. 

running.


chipper blades or shredder knives.




Chipper blade to anvil clearance
is incorrect.




