Owners Manual v.3 User guide

4 INCH CHIPPER
15
ENGLISH
SERVICE & MAINTENANCE
WARNING
BEFORE INSPECTING OR SERVICING ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE AND MAKE SURE
ALL MOVING PARTS HAVE COME TO A COMPLETE STOP.
To remove the chipper blades:
1. Remove the retaining bolt that holds the access cover

2. Tilt access cover over to allow rotor access. Rotate
the rotor so that the bolts holding a chipping blade are
most accessible.
3. 

have two edges per blade and can be reversed one


4. Reinstall chipping blades and proceed with chipping.
5.2 CHIPPER BLADE MAINTENANCE
WARNING
       

Figure 5.2, Sharpening the chipper blades
Figure 5.1, Rotor access cover
5.3 REMOVING THE BLADES
5.4 SHARPENING THE BLADES
NICK GREATER
THAN 1/8”
CRACK
GREATER
THAN 1/8”
BROKEN
CORNER
CHIPPING
SLOT
NEW
BLADE
CHIPPER
DISC
BLADE IS
TOO SHORT,
MUST BE
REPLACED
CHIPPER
DISC
CHIPPING
SLOT


CHECK THE SHARPNESS OF THE BLADES EVERY
5 - 15 HOURS OF OPERATION AND SHARPEN AS
NEEDED.

• 
chipper.
• 
•       

       

• 

 


           

 
blades. This will cause the edge to roll and the blade will

 


 
become overheated and change color. This will remove
the heat-treated properties.
 

45°
.25
MOUNTING SURFACE
(DO NOT GRIND)
MOUNTING SURFACE
(DO NOT GRIND)
SHARPENED
SURFACE
SHARPENED
SURFACE