Instruction Manual

6 INCH CHIPPER
11
4.4 FEED ROLLER CONTROL BAR
1.

increases as the arm is moved.
2.
   3.
control arm in the reverse direction. Remove the branch

Feed Roller
Control Bar
Forward
Reverse
Neutral
4.3 OPERATING THE CHIPPER
WARNING

Failure to operate the machine in accordance with
MAY RESULT IN PERSONAL
INJURY!
CAUTION
        
operating the machine.


pants and a long-sleeved shirt.
       


WARNING
Never        
into the cutting device. Use a push stick or brush
paddle.
Never



Never
Never 
in the chute.
         


Run unit at full operating speed 1. 
chip material.
Limbs fed in to the chipper chute must be 6 inches 2.
(15 cm) in diameter or less. Trim side branches that

Hold small diameter branches together in a bundle and

Exclude pieces of metal, rocks, bottles, cans, and 3.
other foreign objects
machine.
Feed brush from the side of the chipper chute,4.


Place limb, butt end first, into the chipper chute 5. until



If the engine slows to where it may stall,6. 
material and allow the engine to recover. Feed material

If the chipper jams, 7. remove the branch and rotate it


will not kill the engine.
Do not use the clutch to clear a plugged rotor. 8. This

clearing a plugged rotor in the Service and Maintenance
section.
Alternate greener material with dry material 9. to



Sharpen the chipping blades periodically. 10. Check


instructions.