Instruction Manual

6 INCH CHIPPER
10
Section
1. Move throttle to SLOW position.
2. Depress belt engagement pedal.
 

 
release the belt engagement pedal to help slow the
rotor once the engine has stopped running.
4.2 STOPPING THE CHIPPER
NOTE

          
that the rotor has stopped when no noise or machine
vibration is present. Inserting a branch into the chipper
chute to contact the blades will slow the rotor and
shorten stopping time.
OPERATION
4
WARNING
       
       

WARNING
       
      
       
      



        

CHIPPING OPERATION
         
machine, where hardened steel chipper blades are

chipper chute is sliced into small chips and propelled out
through a discharge tube.
1.
2.

MIX OIL WITH GASOLINE.
3.
positions. Place the choke control to the ON position.

partial choke.
Disengage drive belts, which will enable engine to 4.

    
STARTING.
Activate the starter switch. Release the switch as soon 5.
       
seconds.
Move choke lever to RUN position.6.
4.1 STARTING THE CHIPPER
Once engine is running and no choke is needed, 7.

the rotor to turn.
8.
or increase engine RPM.
9.

running RPM.
       10.
clockwise or counterclockwise. Press down on the




can also turn 360 degrees.
NOTE
        
