Instruction Manual

6 INCH CHIPPER
6
Section
2.2 ATTACH CHIPPER CHUTE
1.
       

the bottom.
2.
1-1/2” CARRIAGE BOLT
3/8” WASHER
3/8” NYLOCK NUT
Fig. 2.1, Attaching the chipper chute for the gravity feed model
ASSEMBLY
2.1 TRAILER WHEELS AND HITCH
1.

    2.
device.
3.
the supplied lug nuts.
        4.

NOTE


Do not operate this unit without the chipper chute
      

WARNING
2
2.3 CONNECT THE CONTROL CABLE
INSERT CABLE
THROUGH HOLE
NUT
CLEVIS
ASSEMBLY
DETENT
BALL
FEED
CONTROL
LEVER
CABLE
ANCHOR
WELDMENT
HYDROSTAT
CONTROL
CABLE
      1.

the cable end. Insert the cable end into the hole in
the cable anchor weldment. Replace the nut and the

2.

3.

Fig. 2.3, Control Cable Assembly
1-1/2” CARRIAGE
BOLT
3/8” NYLOCK
NUT
MODEL CH6614
MODEL CH6614H
Fig. 2.2, Attaching the chipper chute for the hydraulic feed model