Manual

Instruction Sheet
5
LUBRICATION
Lubricate the blower periodically with a lithium-based grease. Extreme working conditions will require more frequent
greasing.
Grease the following points every 50 hours of operating time:
Grease zerk located on the idler arm,•
Grease zerk on discharge tube base.•
Lubricate the rest of the chipper/shredder as indicated in your owner's manual.
Do not over grease bearings. Overfilling can lead to
excessive heat and/or unseating of the seals. Add
grease slowly and under light pressure. Whenever
possible, rotate bearing slowly while lubricating.
NOTE
Polyurea and lithium-based greases are not compatible.
Mixing the two grease types may lead to premature
failure.
IMpORTANT
DO NOT OPERATE THIS EQUIPMENT IN THE VICINITY OF
BYSTANDERS. DO NOT ALLOW CHILDREN TO OPERATE
THIS EQUIPMENT. ALWAYS STAND CLEAR OF DISCHARGE
AREA WHEN OPERATING THIS MACHINE. KEEP FACE
AND BODY AWAY FROM DISCHARGE AREAS.
DO NOT OPERATE MACHINE WITHOUT SHIELDS IN PLACE.
FAILURE TO DO SO MAY CAUSE SERIOUS INJURY OR
DEATH.
pN 12173 pN 12174
BEFORE INSPECTING OR SERVICING ANY PART OF THIS
MACHINE, SHUT OFF POWER SOURCE, REMOVE KEY,
DISCONNECT THE BATTERY CABLES AND MAKE SURE ALL
MOVING PARTS HAVE COME TO A COMPLETE STOP.
pN 18993-00
SAFETy DECALS
Familiarize yourself with all of the safety and operating decals on the machine and the associated hazards. See the
engine owner’s manual or contact the engine manufacturer for engine safety instructions and decals. Make certain that
all safety and operational decals on this machine are kept clean and in good condition. Decals that need replacement
must be applied to their original locations.
pN 18984-00
MOVE CONTROL LEVER TO SLOW FOR EXTRA POWER
WHEN CHIPPING. MOVE CONTROL LEVER TO FAST WHEN
USING THE VACUUM HOSE. DO NOT OPERATE MACHINE
WITHOUT GUARDS AND DISCHARGE SCREEN IN PLACE.