User Manual

Echo 2 User Guide
13
Headphone Routing
Normally, the headphones have their own D/A converter separate from the main
outputs. This means that one track can play out of the main outputs, while another
track plays out of the headphones. This is useful for DJ applications, or if you want to
send different mixes to different musicians.
There are times, such as listening to an iTunes playlist, when it is useful to have the
headphones mirror the main outputs, and playback channels 1 and 2. To put the
headphone output into this mode, press and hold the headphone button for two seconds
until the LED starts to flash. To return to normal operation, press and hold the
headphone button for two seconds again.
Steady LED – Headphones are USB playback channels 3 and 4.
Flashing LED – Headphones are USB playback channels 1 and 2.
Saving Settings
Settings are automatically saved to flash memory inside the Echo 2. The Echo 2 will
wait 30 seconds after your last change and then save your settings. The panel will flash
briefly during the save operation.
When you power up the Echo 2, your settings will be restored. However, phantom
power will always be turned off. If no cable is plugged into an input, that input will be
reset to LINE mode with 0 dB of gain.